1/32 P-47D Thunderbolt - Super Riveting Set - Riveting Sets - Hasegawa
Sada obsahuje:
1x P-47D - Riveting Set 1/32 - 321022
1x P-47D Thunderbolt - Stencils + Placard - 1/32 - 232029
1x P-47D Thunderbolt - Seatbelts 1/32 - 132532
1x P-47D Thunderbolt - Masks 1/32 - 632420
Pracovní postup:
Optimální podklad je Mr. Surfacer 1000 nebo Mr. Base White 1000.*
Očistěte model vlhkým hadříkem, zbavte povrch prachu a mastnoty.
Vystřihněte požadovanou část z nýtovacího archu.
Odstraňte vrchní poloprůhledný papír a nýty namočte do vlažné vody na cca 15 sekund.
Po odmočení od podkladového papíru naneste nýty na povrch modelu, ideálně za použití Mr. Mark Softeru (jednoduše usaďte na kapku přípravku).
Až nýty umístíte, pečlivě vytlačte přebytečnou kapalinu a případné vzduchové bubliny. Smyslem je dostat každý nýt do kontaktu s podkladem.
Nechte schnout minimálně 2 hodiny, ideálně ale třeba přes celou noc.
Na závěr pinzetou opatrně stáhněte vrchní průhlednou fólii a očistěte stopy po transferovém lepidle.
* Při aplikaci nýtů na barevný podklad je nutné předem provést test přilnavosti a doby nezbytné k zakotvení nýtů do povrchu. Obecně platí, že čím hladší povrch tím více času nýty potřebují k dokonalému přichycení.
Show more- Product code: 106-321023
- EAN code: 8591060004739
- Weight: 0.16 kg
- Availability:In stock only 1 pc
- Manufacturer: HGW Models
Place | Availability |
---|---|
Main warehouse - dispatch within 1 day | 1 Pcs |
Scale: | 1/48 |
---|---|
Type: | Aircraft |
Package contents:
1x P-47D - Riveting Set 1/32 - 321022
1x P-47D Thunderbolt - Stencils + Placard - 1/32 - 232029
1x P-47D Thunderbolt - Seatbelts 1/32 - 132532
1x P-47D Thunderbolt - Masks 1/32 - 632420
Instructions:
Convenient undercoat is Mr. Surfacer 1000 or Mr. Base White 1000.*
Wipe the surface with a damp cloth, remove dust and grease.
Cut the required part from riveting sheet.
Remove top translucent paper and dip rivets in the warm water for approx. 15 seconds.
When rivets are separated from its carrier paper apply them on the surface. We recommend to use a spot of Mr. Mark Softer.
Find appropriate position and then push the liquid from below the transfer. The purpose is to get each rivet in touch with the surface.
Let it dry for min. 2 hours, but optimal time could be e.g. over the night.
Finally pull of the top transparent foil / film with sharp tweezers and clean the marks caused by transfer glue.
* While application on coloured surfaces it is needed to make a test of adhesion and of time which is necessary for appropriate attaching of rivets. Generally the smoother surface the more time needed.